[VintageLambo] Re: Espada S1 chassis plate

There should be a VIN (mfg) plate on the left front inside fender well. Locate the three fluid reservoirs(LHD), then move forward, following the fluid lines, about 20cm. The data plate should be riveted there just above the fluid lines.. Aternately, on the right side fender well, is the chassis stamp. Locate the wiper motor and move forward about 8-10cm. Look for an impression in the back side of the fender similar to : **75004xx**. This is the chassis identifier where Bertone stamped it when assembly was complete. I have heard that some cars also have the chassis stamp in the inside of the door jamb, and in the front of the spare tire well. You may find the VIN plate inside the drivers door jamb, just below the latch, but that"s probably been checked already. Good luck, Doc --- In VintageLambo@yahoogroups.com, "miura_sv " wrote: > Can someone on the list with an S1 Espada tell me where I might find > the manufacturer"s plate with the engine and chassis numbers on > them?I"ve searched everywhere under the hood and can"t find it. > > Udo