[VintageLambo] Re: Espada S1 chassis plate

Thanks for the reply, Doc.The only thing I have been able to find is the chassis stamp on the right fender as you described.It reads *750*0056*.There is no VIN plate as most cars have.Does the 56 indicate when the car was produced?Somehow the car was titled in CA as a 1967, though they didn"t start making them until 1968. Udo --- In VintageLambo@yahoogroups.com, "docmirror " wrote: > There should be a VIN (mfg) plate on the left front inside fender > well. Locate the three fluid reservoirs(LHD), then move forward, > following the fluid lines, about 20cm. The data plate should be > riveted there just above the fluid lines.. > > Aternately, on the right side fender well, is the chassis stamp. > Locate the wiper motor and move forward about 8-10cm. Look for an > impression in the back side of the fender similar to : **750 04xx**. > This is the chassis identifier where Bertone stamped it when assembly > was complete. > > I have heard that some cars also have the chassis stamp in the inside > of the door jamb, and in the front of the spare tire well. You may > find the VIN plate inside the drivers door jamb, just below the > latch, but that"s probably been checked already. > > Good luck, > > Doc > > --- In VintageLambo@yahoogroups.com, "miura_sv " > wrote: > > Can someone on the list with an S1 Espada tell me where I might > find > > the manufacturer"s plate with the engine and chassis numbers on > > them?I"ve searched everywhere under the hood and can"t find it. > > > > Udo