Re: small parts casting

I"ve spoken with the fabrication company listed below previously regarding distributor caps made for the espada, but never actually had it done since GT Parts got some in.They were very helpful and i"d give them a call and see what they say. They do a lot of work with the film industry (I met them at an industry convention). Mike Kartsonis Dynamic Fabrication Inc. 2615 S. Hickory St. Santa Ana, CA92707 Business (714) 662-2440 Fax (714) 662-1052 Good luck ----- Original Message ----- From: drakepeterdrake To: VintageLambo@yahoogroups.com Sent: Tuesday, December 03, 2002 2:09 PM Subject: [VintageLambo] small parts casting The door lock supports on the interior of my espada are broken. (see photo of door lock support in my drake espada photo file.) They are not available and I have been looking into having them reproduced. I can get them in plastic, but it"s been suggested that it would be much better to have them cast in brass or bronze and powder-coated, as the plastic parts routinely break. Has anyone had any experience with getting parts cast? Thanks. Peter